Sandvik · قطع غيار الكسارة المخروطية ISO 9001 معتمد · توريد مباشر
V-Belt Spc
أرقام قطع OEM المتوافقة: 875.0285-00
V-Belt Spc
النموذج المتوافق
CH420
التطبيق
Used for torque transmission and speed matching in the crusher drive system, ensuring stable eccentric motion output, suitable for continuous heavy-duty transmission
تعليمات التركيب
1. After installation, check meshing/alignment accuracy within specified tolerances; 2. Turn by hand before initial operation to confirm no binding; 3. Run no-load for 30 minutes to check temperature rise, vibration and noise before applying load
الأسئلة الشائعة
What causes gear noise and how to handle it?
Common causes: tooth wear or pitting, improper meshing clearance, poor lubrication, bearing damage, and excessive installation concentricity deviation. Handling: check oil quality and level, measure tooth-side clearance, inspect tooth face damage; slight wear can be monitored after adjusting clearance, while severe damage requires replacement.
How to correctly select and install pulleys?
Select the pulley model and diameter based on transmitted power and speed, ensuring the groove type matches the belt; during installation, the two pulley axes must be parallel with groove alignment deviation ≤1mm; belt tension should be moderate (15-20mm deflection when pressed); recheck tension after the first 24 hours of operation.
What are the alignment requirements for couplings?
After installation, use a dial indicator to check radial and face runout; for rigid couplings, radial deviation ≤0.03mm and angular deviation ≤0.05mm; for flexible couplings, tolerances can be relaxed but not exceed 0.1mm; poor alignment causes vibration, bearing overheating and premature coupling damage.
نموذج طلب عرض السعر
املأ النموذج أدناه وسيرد فريقنا خلال 24 ساعة بعرض سعر تنافسي.