Sandvik · Pièces d'usure et de rechange pour concasseur à cône ISO 9001 Certifié · Approvisionnement Direct
Shim
Numéros de pièce OEM compatibles: 442.8809-04
Shim
Modèle compatible
CH660
Application
Used for fastening connections or power/motion transmission of components, withstanding tension, compression, shear and alternating loads; a key basic component for equipment reliability
Notes d'installation
1. Use a calibrated torque wrench to tighten to the specified torque; 2. High-strength bolts are tightened in two steps (initial and final) and marked against loosening; 3. Before installation, check that threads are intact, undamaged and free of corrosion
Questions fréquentes
What are the common causes of bolt fracture and how to prevent them?
Common causes: insufficient or excessive preload, fatigue loads, thread damage, corrosion, and improper material selection. Prevention: tighten to the specified value with a torque wrench, check and re-tighten regularly, use anti-loosening measures on critical parts, and avoid use beyond service life.
How to detect wear on shaft parts?
Measure the journal diameter with a micrometer and compare with the original dimension; roundness and cylindricity deviation should be ≤0.02mm; check surface roughness with a roughness tester; repair (spray coating/electroplating) or replace if scratches, pitting or dimensional deviations exceed tolerance.
What are the torque requirements for fastener installation?
Must tighten with a calibrated torque wrench to the torque values specified in the design documents; high-strength bolts (grade 8.8 and above) use the torque method or angle method in two steps (initial and final tightening); mark after tightening for easy loosening inspection.
Formulaire de demande
Remplissez le formulaire ci-dessous et notre équipe vous répondra sous 24 heures avec un devis compétitif.